FOCC simplex fiber optic pigtail SC UPC Multimode 0.9mm fiber optic pigtail
1.Description
SC/UPC MM fiber optic pigtail is a fiber optic cable capped at either end with connectors that allow it to be rapidly and conveniently connected to CATV, an optical switch, or other telecommunication equipment. Having a thick layer of protection, it is used to connect the optical transmitter, receiver, and the terminal box. This is known as "interconnect-style cabling".
2.Feature
1).Low Insertion loss
2).High return loss
3).Good Repeatability
4).Good Interchange
5).Excellent Environmental Adaptability
3.Application
1).Communication rooms
2).FTTH (Fiber to The Home)
3).LAN (Local Area Network)
4).FOS (fiber optic sensor)
5).Fiber Optic Communication System
6).Optical fiber connected and transmitted equipment
7).Defense combat readiness
Type | Standard,Master |
Style | LC,SC,ST,FC.MU,DIN,D4,MPO, SC/APC,FC/APC,LC/APC.MU/APC |
Fiber | Singlemode/Multimode 50/125, 62.5/125 (Multimode) OM2&OM1 50/125, 10G (Multimode) OM3 |
Cable | Simplex, Duplex Φ3.0mm, Φ2.0mm, Φ0.9mm PVC or LSZH |
Polishing Manner | UPC,SPC,APC (8°& 6°) |
Insertion Loss | ≤ 0.1dB (For Singlemode Master) ≤ 0.25dB (For Singlemode Standard) ≤ 0.25dB (For Multimode) Tested by JDS RM 3750 |
Return Loss (Singlemode) | UPC ≥ 50dB SPC ≥ 55dB APC ≥ 60dB (typ.65dB) Tested by JDS RM3750 |
Repeatability | ±0.1dB |
Operating temperature | -400C to 850C |
Geometry Requirement ( Singlemode) | Ferrule Endface Radius 7mm ≤ R ≤ 12mm (For APC) 10mm ≤ R ≤ 25mm (For Standard) Apex Offset ≤ 30 μm (For Master) Apex Offset ≤ 50 μm (For Standard) Undercut -50nm ≤ U ≤ 50nm Tested by DORC ZX-1 |
Use of pigtails
1. The pigtail avoids the loop as much as possible during use, which can reduce the attenuation of the optical signal during transmission.
2. The optical module connected to the pigtail must be matched with the pigtail fiber. The shortwave optical module must be connected to the multimode pigtail. The longwave optical module must be connected to the singlemode jumper to ensure the accuracy of data transmission.
3. The pigtail connector should be kept clean. After use, the connector should be protected and sealed with a protective sleeve to prevent oil, dust and mechanical damage.
4、Before use, the tail fiber ceramic ferrule and the ferrule end face cotton must be wiped clean with alcohol.
5. When there is damage to the pigtail caused by man-made or other factors, replace the damaged jumper in time.